|
Replacement Ejection Pins, -H, pk/5
|
|
|
Quantity in Basket:
None
Catalog No.: EJECT-H
Price: $12.00
Shipping Weight: 0.20 pounds
|
|
EJECT-H is the catalog number for ejection pin set of 5 replacement wires for
your internal punch, for the -H type point form die.
PLEASE NOTE:
These are NOT metal tip seating ejectors or synchronized bleed-hole point form die ejectors! They are simple spring wire replacements for a conventional PF-1-H open tip point forming die. If you need a replacement synchronized punch for your PF-1-HT, PF-1-HB, or similar point former with a .157 or larger synchronized ejection pin, then please order the PUNCH-HI instead. These wire pins are not the same thing and will not work for that kind of die...
Select the diameter that is marked on the end of your die,
or on the head of the punch. This will be a decimal
number from .049 to .134 inch diameter, in most cases. The
ejection pins are held in the punch head with a set screw.
For a chart of standard ejection pin sizes, see Corbins.com/pinsizes.htm
Ejection pins are made of an alloy steel with heat treatment specific to end loading resistance. They are not suitable for use as side-loaded components. Do not order them instead of the retraction pin, for example, or for use as cross pins for other purposes. Also, they are protected within the ram and die body when being used normally, and acquire swage lube from operating conditions, which helps protect the metal from rust and corrosion. The CHP-PIN is made of stainless steel heat treated for resistance to bending, with a polished and ground finish. It is more resistant to corrosion and rust without protection, which is good because it is handled and pushed into and out of the ram slot when changing internal punches, which in turn pushes lubricant off and exposes the surface to the atmosphere. In short, the components are designed and built to do specific jobs, with many details taken into consideration. Using the right component is essential for proper operation and longer tool life.
|
|